Filter
Top Products
II) V24/RS232/485 Interface - Single Analyzers and Systems
90003752(1) [AK-Commands] 10/98
AK
2 - 5
2. List of all Codes
2.1. Control commands
CODE Function Page
SALI Kn Mm Linearization check with spangas 2 - 8
SARA Kn Autoranging "OFF" (located range will remain) 2 - 9
SARE Kn Autoranging "ON" 2 - 9
SATK Kn Autom. calibration
(zero and span calibration + zerogas + stand-by)
2 - 10
SEGA Kn Spangas (spangas will flow with time limit) 2 - 15
SEMB Kn Mm Set range (1, 2, 3, 4) 2 - 16
SFRZ Kn Decimal point setup for floating point format 2 - 18
SGTS Kn Device test 2 - 19
SHDA K0 Hold mode "OFF" 2 - 20
SHDE K0 Hold mode "ON" 2 - 20
SINT Kn Start integration (integral average) 2 - 21
SLCH Kn Mm Linearization check (with gas distribution) 2 - 22
SLIN Kn Mm Linearization
(with determination of corrections and saving)
2 - 23
SLST Kn Set linearization step and get values 2 - 24
SMAN Kn Operation mode "Manual" 2 - 25
SMGA Kn Samplegas (will be sucked or will be on) 2 - 26
SNAB Kn Zerogas calibration 2 - 27
SNGA Kn Zerogas (zerogas will flow with time limit) 2 - 28
SPAB Kn Spangas calibration 2 - 29
SPAU Kn Pause (resting status, e.g. pumps, ozonator, deozonator, high
voltage off, gas input closed within the device)
2 - 30
SQEF Kn Mm Cross interference (only for CO analyzers) 2 - 31
SREM Kn Operation mode "Remote" 2 - 32
SRES Kn Reset (analyzer will change via initializing mode to stand-by) 2 - 33
SROF Kn Delay modus "OFF" (operation mode: signal output with/without
delay time, involved are SINT, AKON, AIKO, AIKG, analog signal)
2 - 34
SRON Kn Delay modus "ON" (analog to "SROF") 2 - 34
SSPL Kn Purging (purge air will be sucked or will be on) 2 - 35
ST9O Kn Set t
90
time step (S = fast, M = medium, L = slowly) 2 - 36
STBY Kn Stand-by (get ready for measurement no matter of the previous
history)
2 - 37
Optional:
SCAL Kn Start system calibration (only for platform) 2 - 13
SENO Kn NO measurement (operation mode CLD) 2 - 17
SNOX Kn NO
x
measurement (operation mode CLD) 2 - 17
Kn:
Channel n
Mm:
Range m
Response
The response to the control commands will contain the CODE of the control command and
the error status byte (0-9).