Filter
Top Products
EVEZ – Write command "Delay and synchronization time"
With this write command the analyzers in a system or the single analyzer will get the delay
time and the synchronization time for the called channel (device). The delay time will be
used for integrators started by "SINT" or for the delayed record of valid signals. The
synchronization time will be used for the output of values that were read by "AKON",
"AIKO" and "AIKG" from an internal buffer. The same synchronization time will also delay
the analog signal of these values. This procedure will be started by the control command
"SRON" or will be finished by the control command "SROF".
Write command
EVEZ K0 XXX YYY
EVEZ Kn XXX YYY
Synchronization time
Delay time
Read of channel n
Code
Response
EVEZ 0
Error status
Code
2 - 102
AK
90003752(1) [AK-Commands] 10/98