Filter
Top Products
Configuration
Document 800-00918 Rev E 99
12/07
Setting up Disk S.M.A.R.T. (Self-Monitoring Analysis and Reporting
Technology)
1. Highlight the Setup… field beside Disk S.M.A.R.T., and press . The S.M.A.R.T.
Setup screen appears.
Figure 3-74 S.M.A.R.T Setup Screen
2. Highlight Enable and press to toggle between On and Off.
Note If Enable is turned Off, you are not be able to make changes to
any of the fields.
3. Highlight the field beside Check Time and press . You can select from
Monthly, Weekly, and Daily.
If you select Monthly, you are asked to set the Day of the Month and the Time.
If you select Weekly, you are asked to set the Day of the Week and the Time.
If you select Daily, you are asked to set the Time.
4. Highlight the first field beside Temperature Threshold and press . Use the
UP and DOWN arrows to scroll through the numbers. Refer to the hard disk drive
manufacturer's documentation for the correct temperature setting.
If the temperature of hard disk drive exceeds the defined threshold, the system
triggers an alert.
5. Highlight the second field beside Temperature Threshold and press . Select
either ºC (Celsius) or ºF (Fahrenheit), and press .
The field beside Last Check-Time displays the Date and Time of the last
S.M.A.R.T. check.
6. Highlight OK and press to accept the changes. Select Cancel to exit the
screen without saving the changes.
7. Select Save and then press to save your changes.
Setting Up System Event Actions
The DVR can be set to react to system events. System events can:
• be associated with an Alarm-Out connector
• sound the DVR internal buzzer
• notify a number of different devices.