Filter
Top Products
Installation
24
Your DVR can be used with either NTSC or PAL equipment.
Note You cannot mix NTSC and PAL equipment. For example, you
cannot use a PAL camera and an NTSC monitor.
Connecting the Video Source
Connect the coaxial cables from the video sources to the BNC Video In connectors.
Figure 2-2 Video Input Connectors
Connecting the Loop Through Video
If you would like to connect your video source to another device, you can use the Loop
BNC connectors.
Figure 2-3 Video Loop Through Connectors
Note The Loop BNC connectors are auto terminated. Do NOT connect
a cable to the Loop BNC unless it is connected to a terminated
device because it will cause poor quality video.
Table 2-1 Rear Panel Connections
# Connection # Connection
1 Video input 6 Network/Ethernet port
2 Looping connectors 7 RS485 port for remote devices
3 Audio input x2; audio output x1 8 Alarm inputs
4 Video main: BNC or VGA;
Spot-BNC
9 Alarm outputs
5 Serial RS-232C port 10 Power cord connector