Filter
Top Products
Operation
Document 800-00918 Rev E 115
12/07
Exiting the PTZ Mode
Press PTZ to exit the PTZ mode.
Recording
Recording Video
After you have installed the DVR following the instructions in Chapter 2, Installation, it is
ready to record. The DVR starts recording based on the settings you made in the
Record setup screen. See Chapter 3, Configuration.
Recycle On
or Recycle
Off
The DVR records over the oldest video once the hard disk is full. The factory default is
Recycle On. Setting the DVR to Recycle Off causes it to stop recording once the hard
disk is full.
Standard or
High
When set to Standard (factory default), the DVR has a maximum recording speed of 120
ips. When set to High, the DVR has a maximum recording speed of 60 ips.
Panic Recording
Pressing PANIC starts panic recording of all cameras, and pressing the button again
stops panic recording. If you set the Panic Recording Duration in the Record Screen,
panic recording stops automatically according to the preset duration as long as PANIC
is not pressed.
Exit the toolbar
Click the empty space under and drag the toolbar to where you want it
located.
To re-display the toolbar, position the mouse pointer at the bottom of the
screen.
Table 4-5 PTZ Toolbar Tools
Icons Action