Filter
Top Products
125
Comp2 (Compressor2)
This effect adds Pre LEQ and Pre HEQ to Comp1.
Lmtr (Limiter)
AmpSim (Amp Simulator)
MicSim (Mic Simulator)
Refer to 123.
Decima (Decimator)
ODHiG (OverDrive/HighGain)
ChFl1 (Chorus/Flanger)
ChFl2 (Chorus/Flanger2)
Phaser
Trml
(Tremolo)
Mt.Dly (Multitap Delay)
Reverb (Mono Reverb)
Gate
The Gate of 86:MM32: Reverb-Gate is connected to the
Wet output of the reverb.
This means that the on/off switch of the Gate effect is
linked to the Reverb, and will be switched on/off in con-
junction with the Reverb.
Sense (Sensitivity)............................1...100 Sets the sensitivity
Attack (Attack)..................................1...100 Sets the attack level
Trim (EQ Trim) ..................................0...100 Sets the EQ input level
LEQG (Pre HEQ Gain [dB])......–15...+15dB Sets the gain of High EQ
HEQG (Pre LEQ Gain [dB])......–15...+15dB Sets the gain of Low EQ
Level (Output Level) .........................0...100 Sets the output level of the compressor
Ratio (Ratio)..................1.0:1...50.0:1, Inf:1 Sets the signal compression ratio
Thrshl (Threshold [dB]).................–40...0dB Sets the level above which the com-
pressor is applied
Attck (Attack)....................................1...100 Sets the attack time
Relse (Release)................................1...100 Sets the release time
GLevel (Gain Adjust [dB]).–Inf, –38...+24dB Sets the limiter output gain
Type (Amplifier Type)............SS, EL84, 6L6 Selects the type of guitar amplifier
LPF (Pre LPF)..................................Off, On Selects whether the harmonic noise
caused by a decrease in sampling fre-
quency is generated or not
Fs(Sampling Frequency [Hz])....1.0k...44.1k Sets the sampling frequency
Bit (Resolution)...................................4...24 Sets the data bit length
HiDamp (High Damp [%]).................0...100 Sets the ratio of cut of the high range
Level (Output Level) .........................0...100 Sets the decimator output level
Mode (Drive Mode)
......................OD(Overdrive), HiG(Hi-Gain)
Switching between overdrive and
hyper-gain mode
*Drive (Drive) .....................................1...100 Sets the degree of distortion
Level (Output Level) ...........................0...50 Sets the overdrive output level
LoFc (Low Cutoff [Hz]) ..........20Hz...1.0kHz Sets the center frequency for Low EQ
(shelving type)
LoG (Gain [dB])........................–18...+18dB Sets the gain of Low EQ
Md1Fc (Mid1 Cutoff [Hz])
..........................................300Hz...10.0kHz
Sets the center frequency for Mid/High
EQ 1 (peaking type)
Md1Q (Q) .....................................0.5...10.0 Sets the band width of Mid/High EQ 1
Md1G (Gain [dB]).....................–18...+18dB Sets the gain of Mid/High EQ 1
Md2Fc (Mid2 Cutoff [Hz])
..........................................500Hz...20.0kHz
Sets the center frequency for Mid/High
EQ 2 (peaking type)
Md2Q (Q) .....................................0.5...10.0 Sets the band width of Mid/High EQ 2
Md2G (Gain [dB]).....................–18...+18dB Sets the gain of Mid/High EQ 2
DTime (Delay Time [msec])..... 0.0...50.0ms Sets the delay time
LFO (LFO Waveform)....................TRI, SIN Selects LFO Waveform
*Speed (Frequency [Hz])..........0.02...20.0Hz Sets the LFO speed
*Depth (Depth)...................................0...100 Sets the depth of LFO modulation
Fdback (Feedback)...................–100...+100 Sets the feedback amount
Mix (Wet/Dry) ..................–Wet...–1:99, Dry,
1:99...Wet
Sets the effect balance of the chorus/
flanger
DTime (Delay Time [msec])..... 0.0...50.0ms Sets the delay time
LFO (LFO Waveform)....................TRI, SIN Selects LFO Waveform
*Speed (Frequency [Hz])..........0.02...20.0Hz Sets the LFO speed
*Depth (Depth)...................................0...100 Sets the depth of LFO modulation
Fdback (Feedback)...................–100...+100 Sets the feedback amount
EQTrim (EQ Trim).............................0...100 Sets the EQ input level
LEQG (Pre LEQ Gain [dB])......–15...+15dB Sets the gain of Low EQ
HEQG (Pre HEQ Gain [dB]).....–15...+15dB Sets the gain of High EQ
Mix (Wet/Dry) ................. –Wet...–1:99, Dry,
1:99...Wet
Sets the effect balance of the chorus/
flanger
LFO (LFO Waveform)....................TRI, SIN Selects LFO Waveform
*Speed (LFO Frequency [Hz])..0.02...20.0Hz Sets the LFO speed
Manual (Manual)............................... 0...100 Sets the frequency to which the effect is
applied
*Depth (Depth)...................................0...100 Sets the depth of LFO modulation
Reso (Resonance) ...................–100...+100 Sets the resonance amount
Mix (Wet/Dry) ................. –Wet...–1:99, Dry,
1:99...Wet
Sets the phaser effect balance
LFO (LFO Waveform)...................TRI, SIN,
Vintage, Up, Down
Selects LFO Waveform
Shape (LFO Shape).................–100...+100 Determines how much the LFO wave-
form is changed
*Speed (LFO Frequency [Hz])..0.02...20.0Hz Sets the LFO speed
*Depth (Depth)...................................0...100 Sets the depth of LFO modulation
T1Time (Tap1 Time [msec])......... 0...680ms Sets the Tap1 delay time
T2Time (Tap2 Time [msec])......... 0...680ms Sets the Tap2 delay time
T1Lvl (Tap1 Level)............................0...100 Sets the Tap1 output level
Fdback (Feedback)...................–100...+100 Sets the Tap2 feedback amount
HiDamp (High Damp [%]).................0...100 Sets the damping amount in the high
range
Mix (Wet/Dry) ..............Dry, 1:99...99:1, Wet Sets the effect balance of the multi-tap
delay
Time (Reverb Time [sec])........0.1...10.0sec Sets the reverberation time
HiDamp (High Damp [%])..............0...100% Sets the damping amount in the high
range
PreDly (Pre Delay [msec])........0...200msec Sets the delay time of the reverb sound
and gate control signal
EQTrim (EQ Trim).............................0...100 Sets the EQ input level
LEQG (Pre LEQ Gain [dB])......–15...+15dB Sets the gain of Low EQ
HEQG (Pre HEQ Gain [dB]).....–15...+15dB Sets the gain of High EQ
RevBal (Reverb Balance)...Dry, 1:99...99:1,
Wet
Sets the effect balance of the reverb
Contrl (Input Reverb Mix)...Dry, 1:99...99:1,
Wet
Sets the balance between the dry and
reverb sounds of the gate control signal
Polrty (Polarity)......................................+, – Switches between non-reversed and
reversed Gate on/off
Thrshl (Threshold)............................0...100 Sets the level to which the Gate is
applied
Attack (Attack)..................................1...100 Sets the attack time
Relse (Release)................................1...100 Sets the release time
EffectIns(1in1outx4)