Filter
Top Products
1
Handling of the internal
hard disk
Do not apply physical shock to this device. In partic-
ular, you must never move this device or apply
physical shock while the power is turned on. This
can cause part or all of the data on disk to be lost, or
may damage the hard disk or interior components.
When this device is moved to a location where the
temperature is radically different, water droplets
may condense on the disk drive. If the device is used
in this condition, it may malfunction, so please allow
several hours to pass before operating the device.
Do not repeatedly turn the power on/off. This may
damage not only the D1600, but also any SCSI
devices that are connected.
This device begins to access the hard disk immedi-
ately after the power is turned on.
Never turn off the power while the HDD access indi-
cator is lit or blinking. Doing so can cause all or part
of the data on disk to be lost, or may cause malfunc-
tions such as hard disk damage.
If the hard disk has been damaged due to incorrect
operation, power failure, or accidental interruption
of the power supply, a fee may be charged for
replacement even if this device is still within its
warranty period.
Caution when transporting the D1600
When transporting the D1600, please pack it in the
carton and shock-absorbing material in which it was
originally packed.
If an internal IDE hard disk (e.g., HDD-20G) or inter-
nal CD-R/RW drive (e.g., CDRW-2) is installed, you
must remove them from the D1600 and pack them in
their own carton for transportation. Please take care
that these units are not subjected to physical shock
or vibration during transportation.
If the D1600 is transported with the hard disk and/
or CD-R/RW drive installed, data may be lost, or the
D1600, hard disk, or CD-R/RW drive may malfunc-
tion.
For customers using the CDRW-2 drive
Phantom Power
To prevent hazard or damage, ensure that only
microphone cables and microphones designed to
IEC-268-15A are connected.
COPYRIGHT WARNING
This professional device is intended only for use
with works for which you yourself own the copy-
right, for which you have received permission from
the copyright holder to publicly perform, record,
broadcast, sell, and duplicate, or in connection with
activities which constitute “fair use” under copy-
right law. If you are not the copyright holder, have
not received permission from the copyright holder,
or have not engaged in fair use of the works, you
may be violating copyright law, and may be liable
for damages and penalties. If you are unsure about
your rights to a work, please consult a copyright
attorney.
KORG TAKES NO RESPONSIBILITY
FOR ANY INFRINGEMENT COMMITTED
THROUGH USE OF KORG PRODUCTS.
CAUTION FOR LASER
This product has been designed and manufactured according to FDA
regulations “title 21. CFR. Chapter J. based on the radiation Control
for Health and Safety Act of 1968”, and is classified as a class 1
laser product. There is no hazardous invisible laser radiation during
operation because invisible laser radiation emitted inside of this
product is completely confined in the protective housings.
The label required in this regulation is shown bellow.
CAUTION
Use of controls or adjustments or performance of procedures other
than those specified herein may result in hazardous radiation
exposure.
Optical pickup
Type: KRS-202A
Manufacturer: SONY CORPORATION
Laser output: Less than 0.1mW(Play) and 32mW(Record) on the
objective lens
Wavelength: 777-787nm
* Appearance and specifications of this product are subject to change without notice.
• Company names, product names, and names of formats etc. are the trademarks or registered trademarks of their
respective owners.