Filter
Top Products
10 - 11
MELSEC-F
USING THE E-MAIL FUNCTION10
10 - 11
(c) SMTP authentication setting
1) Set the authentication method for the outgoing mail server (SMTP).
The steps 2) and 3) below are required when "SMTP-AUTH" is selected in
the SMTP authentication method.
2) Set the login ID of the outgoing mail server (SMTP).
3) Set the password of the outgoing mail server (SMTP).
NOTE
To adjust the settings in FX Configurator-EN, select [Email Settings] from the initial
screen and adjust the settings from the email settings screen.
An Ethernet module V1.10 or later and FX Configurator-EN V1.20 or later is
necessary to use the SMTP authentication setting.
(3) Send mail address setting
Register the e-mail address of the external devices where e-mail is to be sent.
[Setting item]
(a) Send mail address
1) Designate the mail addresses of a maximum of 10 external devices to
which mail is being sent from the local station's Ethernet module. (Only
one e-mail address can be specified for each area.)
2) When sending e-mail by the Ethernet module, specify the send e-mail
address by the bit 0 to 9 of BFM#10337.
NOTE
To adjust the settings in FX Configurator-EN, select [Email Settings] from the initial
screen and adjust the settings from the email settings screen.
Setting Item name
BFM number
[Decimal]
Description of setting
Setting
range/Selections
Send mail address 1
to
Send mail address 10
9987
to
10306
Set the mail address of the transmission
destination (1 to 10)
—