Filter
Top Products
4 - 8
MELSEC-F
SETTINGS AND PROCEDURES PRIOR TO OPERATION4
4 - 8
4.4.1 Connecting to the 10BASE-T/100BASE-TX network
This section explains how to connect the Ethernet module to the 10BASE-T,
100BASE-TX network.
The following shows the connection diagram for the twisted paid cable.
<Operating procedure>
(Step 1) Connect the twisted-pair cable to the hub.
(Step 2) Connect the twisted-pair cable to the Ethernet module.
POINT
(1) The Ethernet module detects whether it is 10BASE-T or 100BASE-TX, and in
full-duplex or half-duplex transmission mode automatically according to the
hub.
For connection to the hub without the auto detection function, set the half-
duplex mode on the hub side.
(2) For 10BASE-T or 100BASE-TX connection required devices and a sample
system configuration, refer to Section 2.2 (1) and (2).
RJ45 type modular
RJ45 type modular jack
shielded twisted-pair cable
(Category 3, 5, 5e)