Filter
Top Products
106
Basic features
Setting No Signal Power Down
Setting No Signal Power Down
When an input's setting in this feature is set to On, The TV will
automatically turn itself off after 15 minutes if no signal is detected.
You can change each input's setting to Off: ANT/CABLE, Video 1,
Video 2, ColorStream HD1, ColorStream HD2, HDMI 1, HDMI 2,
HDMI 3, HDMI 4, or PC.
1 Press the MENU button. Select SETTINGS,
PREFERENCES, Power Management, and then press the
OK button.
2 Press the ( / arrow) buttons to select No Signal Power
Down, and then press the OK button.
3 Press the ( / arrow) buttons to highlight the item you want
to change.
4 Press the ( / arrow) buttons to select On or Off. Press the
EXIT button.
❖ Default setting for each input is On.
❖ A warning message will appear 1 minute before turning off.
Displaying TV status information
To display TV status information, press the INFO button.
The following information will be displayed (if applicable):
❖ Current input (ANT/CABLE, Video, etc.)
❖ Either “CABLE” (for cable TV) or “ANT” (for over-the-air
broadcasts), if ANT/CABLE is the current input
❖ Channel number (if in ANT/CABLE mode)
❖ Input label (if set)
❖ Digital signal strength indicator (bar graph in lower right
corner of box; for ATSC signals only)
❖ Stereo, Mono, or SAP audio status (when in HDMI
®
input
mode, PCM)
❖ Video resolution
❖ Aspect ratio of incoming video signal (4:3 or 16:9)
❖ V-Chip rating status (if available)
❖ GameTimer (if set)
NOTE