Filter
Top Products
66
Setting up your TV
How to navigate the menu
3 Press the ( / arrow) buttons to select Home.
4 Press the OK button.
ANT/CABLE In
This setting configures the antenna input source for the
ANT/CABLE terminal.
1 Press the MENU button.
2 Select SETTINGS, SETUP, and then ANT/CABLE In.
3 Select Antenna or Cable and press Next.
4 Select Cable and press Next.
If you do not want to scan channels, you do not need to make a
selection for ANT/CABLE. Select Next and press OK to skip this
step.
5 Select Start Scan.
After scanning is complete, the auto tuning results screen will
appear.
6 Press OK or EXIT.
Storing channels in memory (optional)
To make sure your TV stops only on the channels you want when
you press the CH Up/Down arrow buttons on the remote control or
the control panel, store those channels in the TV’s memory.
Auto Tuning
You must set up the antenna/cable input source first. See “Initial
setup” on page 51.
You can set up the TV to detect all active channels in your area and
store them in its memory. Then you can manually store or skip
individual channels from memory.
Option: Description:
Cable
Note: If you select Cable, auto tuning deletes previously stored
channels from memory.
This setup requires some time, but you do not need to repeat the
setup unless your cable TV service’s lineup changes significantly.
NOTE
NOTE