Filter
Top Products
67
Setting up your TV
How to navigate the menu
To tune to channels not stored in memory, use buttons 0–9 and the
DASH button on the remote control.
1 Press the MENU button.
2 Select SETTINGS, SETUP, Auto Tuning, and then press the
OK button.
A confirmation screen appears.
3 Press the OK button to start Auto Tuning or press the EXIT
button to abort.
The TV cycles through the channels and stores all active
channels in memory.
4 To view the programmed channels, press the CH Up/Down
arrow buttons.
Manual Tuning
After storing channels in memory, you can manually enter channels
if the channel number is known.
1 Press the MENU button.
2 Select SETTINGS, SETUP, Manual Tuning, and then press
the OK button.
3 Use buttons 0–9 on the remote control to enter the channel
number (for example, 56).
4 Press the OK button.
5 Press the OK button again to begin Manual Tuning.
The channels found are listed at the bottom of the screen.
Antenna
Auto tuning retains stored channels and stores newly found
channels into memory.
To skip an antenna source channel and remove it from memory, set
the channel to be skipped. See “Skipping channels” on page 68.
Option: Description:
ATV Analog channel
DTV Digital channel
Option: Description:
NOTE