Filter
Top Products
Chapter 3 Preparations
3-1 MAV-555SS Modes 3-5 (E)
This example assumes ports R1 and P1 are controlled from a DTR-3000.
Use the basic menu item LIVE DURATION (menu 034) to set the recording time
for port R1.
For details on basic menu settings and operation sequences, refer to Section 3-4, “Setup” (page
3-18).
When using the BKMA-505 control panel, the following ports can be controlled
through the control panel depending on the settings of the basic menu PORT
CONFIGURATION (menu 042).
Notes
• When using a DTR-3000 with this unit, the DTR-3000 version must be
CP:V01.30, VS:V01.20, or later. Further, the unit must be used in the
DISK:INDIVIDUAL mode. For details, please contact the company from
which you purchased the unit.
• To change from another operation mode to this mode, execute the -ALL
ERASE (menu 099) basic menu item and then reboot.
• When the LIVE DURATION time value is changed, or when recording from
the beginning of the recording area, existing material must be erased. Delete the
“LIVE1” material in the Panel mode and reboot to this mode, or reboot after
erasing all material using the -ALL ERASE (menu 099) basic menu item.
• Material recorded in this mode will be erased when this mode is again selected
from the Panel mode.
2 input/2 output ports R2 and P2 ports
1 input/3 output ports R2 and P3 ports