Filter
Top Products
Chapter 3 Preparations
3-4 Setup 3-35 (E)
712
713
714
BI
NON COMPRESS LINE R1
NON COMPRESS LINE R2
During recording, excludes from compression the three largest scanning lines of the 1st
Field and 2nd Field. The number of lines in the 1st and 2nd fields must be the same.
Note: Set the sequence for continuous line settings as follows.
NTSC : 10, 11, 12, 13, 14, 15, 16, 17, 18, 19, 20, 21, 273, 274, 275, 276, 277, 278,
279, 280, 281, 283, 284
PAL : 9, 10, 11, 12, 13, 14, 15, 16, 17, 18, 19, 20, 21, 22, 322, 323, 324, 325,
326, 327, 328, 329, 330, 331, 332, 333, 334, 335
SUB MENU
when in 525
mode
F1 SELECT 1
F1 SELECT 2
F1 SELECT 3
: Compress.
10line .. 21line : Exclude the specified scan lines from compression.
F2 SELECT 1
F2 SELECT 2
F2 SELECT 3
: Compress.
273line .. 284line : Exclude the specified scan lines from compression.
when in 625
mode
F1 SELECT 1
F1 SELECT 2
F1 SELECT 3
: Compress.
9line .. 22line : Exclude the specified scan lines from compression.
F2 SELECT 1
F2 SELECT 2
F2 SELECT 3
: Compress.
322line .. 335line : Exclude the specified scan lines from compression.
723
724
725
BI
BLANK LINE SELECT P1
BLANK LINE SELECT P2
BLANK LINE SELECT P3
The method for processing the video signal during the vertical blanking intervals
is specified for each line independently.
SUB MENU
when in 525
mode
All Lines
: Specify line blanking for each line.
throu : Turn off blanking for all lines that can be specified in this menu, regardless
of the other SUB MENU settings.
blank : Turn on blanking for all lines that can be specified in this menu, regardless
of the other SUB MENU settings.
Lines 10 .. 19 throu : Do not perform blanking.
: Perform blanking.
Line 20, 21 full : Perform blanking.
: Perform half-blanking.
throu : Do not perform blanking.
Notes: • Although the settings for LINE20 and LINE21 can be made as desired,
actual operation will be as described in the following table. The
underlined portions indicate special operations.
• Initial settings: Line 20: “half”, Line 21: “throu”.
when in 625
mode
All Lines : Specify line blanking for each line.
throu : Turn off blanking for all lines that can be specified in this menu, regardless
of the other SUB MENU settings.
blank : Turn on blanking for all lines that can be specified in this menu, regardless
of the other SUB MENU settings.
Lines 7 .. 22 throu : Do not perform blanking.
: Perform blanking.
Line 23 throu : Do not perform blanking.
: Perform blanking.
Expansion menu items (Continued)
Item number Display indication Settings Description
none
none
none
none
–
blank
half
LINE 20 SETTING
Throu Half Full
LINE 21
SETTING
Throu 20=Throu 20=Half 20=Full
21=Throu 21=Throu 21=Throu
Half 20=Throu 20=Half 20=Full
21=Half 21=Throu
21=Half
Full 20=Throu 20=Half 20=Full
21=Full 21=Throu
21=Full
–
blank
half