Filter
Top Products
Chapter 3 Preparations
3-6 (E) 3-1 MAV-555SS Modes
DTR + DTR Mode (SD mode only)
This mode allows two cameras to be used for a live relay, with replay and slow-
motion playback during recording.
In this mode, the two groups of ports R1/P1 and R2/P2 are controlled from two
DTR-3000 units.
Use the basic menu item LIVE DURATION (menu 034) to set the recording time
for ports R1 and R2.
For details on basic menu settings and operation sequences, refer to Section 3-4, “Setup” (page
3-18).
Notes
• When a DTR-3000 is used with this unit, it must be version CP:V01.30,
VS:V01.20 or later, and this unit must be used in the DISK:INDIVIDUAL
mode. For details, please contact the supplier of the unit or your Sony
representative.
• To change from another operation mode to this mode, execute the -ALL
ERASE (menu 099) basic menu item and then reboot.
• When the LIVE DURATION time value is changed, or when recording from
the beginning of the recording area, existing material must be erased. Delete the
“LIVE1” (and “LIVE2”) material in the Panel mode and reboot to this mode,
or reboot after erasing all material using the -ALL ERASE (menu 099) basic
menu item.
• Material recorded in this mode will be erased when this mode is again selected
from the Panel mode.
Configuration example
Dynamic Motion Controller
DTR-3000
CONTROL PANEL
PANEL SELECTCHARACTER
REAR FRONT
1 2 3
NONE OFFON80TH
SETUP
SELECT
COMPOSITE SDI
VIDEO
INPUT
REMOTE
R1
PORT SELECT
R2/
P3
P1
P2
INPUT
SDI
AES/EBU
ANALOG
CH1
CH1
PRESET
AUDIO INPUT / MONITOR SELECT
CH2 CH3 CH4
MONITOR
L
R
METER
PANEL
525
REMOTE
MENU
LOCAL
CONTROL
PANEL
625
SETUP BANK
TOTAL /
REMAIN
PROCESS
CONTROL
VIDEO
CHROMA
SET UP/BLACK
CHROMA/PHASE
PHONES
123
SYSTEM HDD
HELP
FULL /
FINE
TC/UBTC TYPE
MENU
10
SET
0
CH2
PRESET
CH3
PRESET
CH4
PRESET
VIDEO/MENU
PRESET
Monitor
RS-422
RS-422
SDI/Composite SDI/Composite
monitor
MAV-555SS
Dynamic Motion Controller
DTR-3000
REF.
Sync Generator
REF.
REF.
Video Camera