Filter
Top Products
Chapter 3 Preparations
3-4 Setup 3-23 (E)
3-4-2 Basic Menu Operation
To change the factory default settings, proceed as follows.
1
Set the SET UP SELECT switch on the system setup
panel to the desired menu bank.
Note
When the menu bank is modified after power up, the
MAV-555SS must be restarted or the FAST REBOOT
(menu 027) on the Basic menu must be executed.
(Changes in settings made while the power is off do
not become effective the next time the power is turned
on. It is necessary to start up the system a second
time.)
2
Press the MENU button.
A menu item appears in the time counter display in
the display panel.
3
Turn the MENU control to select the item you want to
change.
Turning the MENU control clockwise increases the
item number, and turning it counterclockwise
decreases the item number.
4
Press the MENU control once.
This allows the setting to be changed, and the setting
value flashes.
Turn the MENU control to change the setting.
5
When the desired setting appears, press the MENU
control once more.
This confirms the setting, and the menu item number
and name starts flashing again.
To change settings in a menu item including a submenu, see the
section, “Menu items with submenus”.
6
To make other menu settings, repeat steps 3 to 5.
7
When the settings are complete, press the SET button.
This saves the settings, and the display returns to
showing a time value.
To cancel setting changes
In step 7 above, before pressing the SET button, press the
MENU button.
This exits the menu mode, without saving the settings.
To change the menu display group by group
To change the menu display group by group, press the
CHROMA button (it is not necessary to hold down the
button).
In this state, turning the MENU control moves from one
menu group to the next. To return to the MAIN MENU
display, press the CHROMA button once more, or click
the MENU control.
Modes of operating the MENU control
It is possible to select either of two modes in which the
MENU control operates when selecting items or changing
settings: either the value changes only when you turn the
control, or the value continues changing even when you
stop turning.
Normally, the state is such that when you use the MENU
control to select items or change settings, the value
changes only when you turn the MENU control (the value
stops changing when you stop turning).
However, if you press the SETUP/BLACK button, turning
on the PRESET indicator above and to the left of the
MENU control, the menu item or setting continues
changing even when you stop turning.
To stop the change when the PRESET indicator is lit, do
any of the following:
COMPOSITE SDI
VIDEO
INPUT
REMOTE
R1
PORT SELECT
R2/
P3
P1
P2
INPUT
SDI
AES/EBU
ANALOG
CH1
CH1
PRESET
AUDIO INPUT / MONITOR SELECT
CH2 CH3 CH4
MONITOR
L
R
METER
PANEL
525
REMOTE
MENU
LOCAL
CONTROL
PANEL
625
SETUP BANK
TOTAL /
REMAIN
PROCESS
CONTROL
VIDEO
CHROMA
SET UP/BLACK
CHROMA/PHASE
PHONES
123
SYSTEM HDD
HELP
FULL /
TIME
TC/UB TC TYPE
MENU
10
SET
0
CH2
PRESET
CH3
PRESET
CH4
PRESET
VIDEO/MENU
PRESET
7
2 3,4,5
Display panel
0 0 2POS: C H A R H -
60
Item number and name flashes
Setting
002 POS:CHARH-
60
Item number and name
Setting flashes