Filter
Top Products
Chapter 5 Basic Functions of Each Mode
5-10 (E) 5-5 Basic Operations in BVE Mode
• This error can be avoided by performing certain
operations through the MAVE-F555. For details, refer
to the “Error Message List” in the appendix in the
MAVE-F555 operation manual.
[Rec Stopped]
This error is generated if nothing is done during the two
minutes after [Nearly Rec Stop] is generated. The disk
is now full, and further recording/editing is not currently
possible.
Remedy:
Delete any unnecessary files.
The next recording operation in the R port will begin
from the start of a new file.
The next manual recording operation in the RP port will
begin from the point where recording was halted.
Editing in the RP port stops automatically, and a new
editing command must be issued.
[Not Enough Space To Rec]
Because the disk is full, there is not enough space to
automatically allocate a four-minute area. Recording/
editing is not possible.
Remedy:
Create free space by deleting any unnecessary files.
Once free space has been created, the four-minute area
will be allocated automatically and the error will be
cancelled.
[Too Much Fragmentation]
Too many fragmented files have been recorded on the
HDD and the limit of processing has been exceeded.
Remedy
From the playback port play back the files that you have
been editing, then by recording the files as new files on
the recording port you can continue editing.
[Temp. File Protected]
The temporary file that you are using in the BVE mode
has been protected in another mode.
Remedy
In any mode other than BVE mode, check the names of
the files. If any file is prefixed with a percent symbol
(%), set Protect Off.