Filter
Top Products
Chapter 3 Preparations
3-28 (E) 3-4 Setup
222 DEFAULT GATEWAY This item specifies the Ethernet* interface default gateway.
SUB MENU
BYTE1
.. 255
BYTE2
BYTE3
BYTE4
223
BI
GPI INPUT CONFIGURATION When GPI CONFIG MODE (menu 225) is “CONFIG,” this item specifies the function
for the GPI pins.
SUB MENU
PIN 1 .. 8 PORT
PIN 18 .. 25 PORT
PIN 34 .. 41 PORT
This item specifies the effect of the set function on each port input pin.
• When the function is not FILE+, FILE-, RECED
• When the function is FILE+, FILE-, RECED
PIN 1 .. 8 FUNCTION
PIN 18 .. 25 FUNCTION
PIN 34 .. 41 FUNCTION
This item specifies the function of the GPI input pins. Also, when GPI CONFIG MODE
(menu 225) is “CONFIG,” this item specifies the function for the GPI input pins.
: No operation.
STOP : Executes the STOP command.
PLAY : Executes the PLAY command.
REC : Executes the REC command.
FF : Executes the Fast Forward command.
REW : Executes the Rewind command.
TOP : Executes the CueUp SOF command.
END : Executes the CueUP EOF command.
STP+1 : Executes the STEP+1 command.
STP-1 : Executes the STEP-1 command.
ST+10 : Executes the STEP+10 command.
ST-10 : Executes the STEP-10 command.
ULOAD : Executes the UNLOAD command.
REMOT : Executes REMOTE (for REMOTE/LOCAL).
LOCAL : Executes LOCAL (for REMOTE/LOCAL).
REC1F : Executes 1-frame recording.
SOFPL : After executing the CueUp SOF command, executes the PLAY command.
FILE+ : Executes file switch in the + direction.
FILE- : Executes file switch in the - direction.
FILE+/FILE- can be used with
• The playback port in the PANEL mode
• Port P2 in the DTR+PANEL mode
• The playback port in the BVE mode.
RECED : Stops on the R2 port, switches files. (BVE mode)
TOPFL : Switches to the beginning of the file list.
* “Ethernet” is a registered trademark of the Xerox Corporation.
Expansion menu items (Continued)
Item number Display indication Settings Description
0
Setting 1 input/3 output 2 input/2 output 3 input/1 output 1 input/1 output
(SS mode)
R1 R1 R1 R1
2P1 P1 P1 P1
3P2 R2 R2
Invalid
4P3 P2 R3
1
Setting 1 input/3 output 2 input/2 output 3 input/1 output 1 input/1 output
(SS mode)
RP(BVE mode) P1(Panel mode)
P1 (Panel mode)
2P2 P2 Invalid
Invalid
3R2
1
NOP