Filter
Top Products
Chapter 3 Preparations
3-4 Setup 3-21 (E)
030
B
DTR CUE LIST CLEAR Selects whether to delete the DTR-3000 cue list when files are unloaded.
: The cue list is deleted.
disable : The cue list is not deleted.
034 LIVE DURATION In the DTR + Panel or DTR + DTR mode, specify the length reserved for recording.
DTR-1 settings apply to the R1/P1 pair, and DTR-2 settings apply to the R2/P2 pair.
Notes: This is affected by the VIDEO COMPRESSION RATE and HDD capacity.
Confirm the available disk space (SysRemain page 2-3), and follow the
notes below on setting. Maximum recording times are shown in the
following table.
• After changing LIVE DURATION, the material must be erased. Delete
the material named “LIVE1” (and “LIVE2”) in the Panel mode and reboot
with DTR+Panel (or DTR+DTR) mode, or reboot after deleting all
materials.
• In DTR+Panel mode, the time specified by this menu must not exceed
SysRemain.
• In DTR+DTR mode, the time specified for DTR-1 plus the time specified
for DTR-2 in this menu item must not exceed the SysRemain time minus 3
minutes.
• If an incorrect setting is specified, the warning message “DM1 File Open
Fail” or “DM2 File Open Fail” appears on the front panel after rebooting.
In this case, make the correct setting, then reboot the unit.
• To record from the beginning of the disk, recorded material must first be
erased. In the Panel mode, delete the material named “LIVE1” (and
“LIVE2”) in and reboot to DTR+Panel (or DTR+DTR) mode, or reboot
after deleting all materials by executing -ALL ERASE (menu 099).
B SUB MENU
DTR-1 HOUR (0 .. .. 23)
DTR-1 MIN ( 0 .. )
DTR-2 HOUR (0 .. .. 23)
DTR-2 MIN ( 0 .. )
DTR-1 LOOP REC
DTR-2 LOOP REC
Specifies whether to record in a loop within the allocated space.
: Record normally
on : Record in a loop. When recording reaches the end of the allocated space,
recording returns to the beginning of the space and continues.
035 VIDEO COMP. RATE This item sets the default value for the recording video rate. (Note that this value is
always used for ports that are used by the DTR in DTR-panel mode or DTR-DTR
mode.)
30M bps
40M bps
042 PORT CONFIGURATION Specifies port configurations for input and output.
:SS mode
2 in 2 out
3 in 1 out :SD mode
1 in 3 out
Basic menu items (Continued)
Item number Display indication Settings
enable
Input/output
signal
30 Mbps 40 Mbps 50 Mbps
Audio 16-bit 20-bit 20-bit 20-bit
SS mode 6 h 20 min 5 h 20 min 4 h 50 min 3 h 40 min
SD mode 19 h 20 min 16 h 14 h 40 min 11 h 20 min
1
59
1
59
off
50M bps
1 in 1 out Super Slow