Filter
Top Products
Chapter 3 Preparations
3-4 Setup 3-29 (E)
224
BI
GPI OUTPUT
CONFIGURATION
When GPI CONFIG MODE (menu 225) is “CONFIG,” this item specifies the function
for the GPI pins.
SUB MENU
PIN 9 .. 16 PORT
PIN 26 .. 33 PORT
PIN 42 .. 49 PORT
This item specifies the effect of the set function on each port output pin.
PIN 9 .. 16 FUNCTION
PIN 26 .. 33 FUNCTION
PIN 42 .. 49 FUNCTION
This item sets the function of the GPI output pins.
: No operation.
LOCAL : Indicates the LOCAL status.
REF : Indicates ALARM-REFERENCE.
COMPL : Indicates port command was completed.
INPRO : Indicates port command is in progress.
TOP : At File Top.
END : At File End.
MPLAY : File was opened in Open Play mode.
MREC : File was opened in Open Rec mode.
MNEXT : File was opened in Open Next mode.
MEDIT : File was opened in Open Edit mode. (DTR mode only)
STBON : STANDBY ON state.
STOP : STOP state.
REW : REWIND state.
FF : FAST FORWARD state.
REC : REC state.
PLAY : PLAY state.
SHUTL : SHUTTLE state.
JOG : JOG state.
VAR : VARIABLE state.
RV/FW : Indicates the playback direction.(displays ON for REV playback)
STILL : STILL state.
CUECP : Cue Up was completed.
SELEE : Selected EE state.
FULEE : Full EE state.
EDIT : Edit state. (BVE mode only)
CUPRE : Either Cue Up or Preroll state. (BVE mode only)
INSPR : Insert Preset enabled. (BVE mode only)
ASMPR : Assemble Preset enabled. (BVE mode only)
VPRST : Video Preset enabled. (BVE mode only)
DA1 : Digital Audio 1 is preset. (BVE mode only)
DA2 : Digital Audio 2 is preset. (BVE mode only)
DA3 : Digital Audio 3 is preset. (BVE mode only)
DA4 : Digital Audio 4 is preset. (BVE mode only)
RECIH : Rec Inhibit enabled.
WPROT : Write Protect enabled.
ENDLS : Endless Mode.
EP1 : Indicates the passage of this IN point. (Only for IN points specified with
the MAVE-F555 in BVE mode.)
*1
READY : Port Not Ready state. (DTR mode only)
EP2 : Indicates the passage of this IN point. (Only for IN points specified with
the MAVE-F555 in BVE mode.)
*1
TEVWR : Displays the warning using the time difference forward function.
TEVER : Displays the error using the time difference forward function.
STOP2 : Either Stopped or UNLOAD state.
*1 Offset control is submitted to MAVE-F555 CONTROL (menu 320). Further, port
settings are unnecessary.
Expansion menu items (Continued)
Item number Display indication Settings Description
Setting 1 input/3 output 2 input/2 output 3 input/1 output 1 input/1 output
(SS mode)
R1 R1 R1 R1
2P1P1P1P1
3P2 R2 R2
Invalid
4P3 P2 R3
1
NOP