Dell Remote Access Controller 4 Firmware Version 1.30 Universal Remote User Manual


 
100 Using the DRAC 4 With Microsoft
®
Active Directory
www.dell.com | support.dell.com
Configuring the DRAC 4 Active Directory Settings Using the racadm CLI
Using the following commands to configure the DRAC 4 Active Directory Feature using the
racadm CLI instead of the Web-based interface.
1
Open a command prompt and type the following
racadm
commands:
racadm config -g cfgActiveDirectory -o cfgADEnable 1
racadm config -g cfgActiveDirectory -o cfgADRacDomain <
fully
qualified rac domain name
>
racadm config -g cfgActiveDirectory -o cfgADRootDomain <
fully
qualified root domain name
>
racadm config -g cfgActiveDirectory -o cfgADRacName <
RAC common
name
>
racadm sslcertupload -t 0x2 -f <
ADS root CA certificate
>
racadm sslcertdownload -t 0x1 -f <
RAC SSL certificate
>
2
If DHCP is enabled on the DRAC 4 and you want to use the DNS provided by the DHCP
server, type the following command:
racadm config -g cfgLanNetworking -o cfgDNSServersFromDHCP 1
3
If DHCP is disabled on the DRAC 4 or you want manually to input your DNS IP address, type
the following commands:
racadm config -g cfgLanNetworking -o cfgDNSServersFromDHCP 0
racadm config -g cfgLanNetworking -o cfgDNSServer1 <
primary DNS
IP address
>
racadm config -g cfgLanNetworking -o cfgDNSServer2 <
secondary DNS
IP address>
4
Press
Enter
to complete the DRAC 4 Active Directory feature configuration.
Using Active Directory to Log In To the DRAC 4
You can use Active Directory to log in to the DRAC 4 through the Web-based interface, with
remote racadm, or through the serial or telnet console.
The login syntax is consistent for all three methods:
<
username@domain
> or <
domain>\<username
> or <
domain>/<username
> (where
username
is an ASCII string of 1–256 bytes). No white space and no special characters (such
as \, /, or @) are allowed in either the user name or the domain name.
NOTE: You cannot specify NetBIOS domain names, such as Americas, since those names cannot be resolved.