Dell Remote Access Controller 4 Firmware Version 1.30 Universal Remote User Manual


 
170 racadm Subcommand Man Pages
www.dell.com | support.dell.com
Output
The serveraction command returns without output if successful.
getraclog
NOTE: To use this command, you must have Log In DRAC 4 permission.
Ta b le A-29 describes the getraclog command.
Synopsis
racadm getraclog -i
racadm getraclog [-A] [-c
count
] [
delay-seconds
]\[-s
start-
record
] [-v] [-V] [-m]
Description
NOTE: The command name and the racadm subcommand names may be different. This is normal.
The getraclog -i command displays the number of entries in the DRAC 4 log.
The following options allow the getraclog command to read entries:
-A
— Provides API-formatted output (no header).
-c
— Provides the maximum count of entries to be returned.
•<
blank
>
— Displays the entire log; racadm and serial only (default).
-d
— Provides the number of seconds to delay the recording of any new log entries.
-s
— Provides the associated number of the first displayed entry (default = 0 [list begins with
the first DRAC 4 log entry]).
-v
— Provides
verbose
output.
-V
— Provides
Very verbose
output.
-m
— Displays 24 rows at a time, and queries for more (such as the UNIX
more
command).
Output
One line of output is displayed for each DRAC 4 log entry.
Table A-29. getraclog
Command Definition
getraclog -i Displays the number of entries in the DRAC 4 log.
getraclog Displays the DRAC 4 log entries.