Filter
Top Products
Managing and Recovering a Remote System 65
Testing an Alert
NOTE: You must have Test Alert permission to test an alert, otherwise this option will not be available.
You can force an alert to be sent to the specified destination IP address. In the SNMP Alert List,
click Test Alert next to the alert you want to test.
NOTE: Only users with Test Alerts permission will have the Test Alert option available next to their names.
Deleting an Alert
In the SNMP Alert List, click Remove Alert next to the alert you want to delete.
Other Options
The SNMP Alerts and Add/Configure SNMP Alerts pages provide the buttons in Table 4-10 in
the top-right corner of the page.
Managing a Remote System
This section provides instructions about how to perform the following systems management
tasks to manage a remote system:
• Updating the DRAC 4 Firmware
• Ensuring DRAC 4 Network Security
• Viewing System Information
• First Steps to Troubleshoot a Remote System
Table 4-9. SNMP Alert Properties
Property Description
Enabled? Displays (Yes or No) whether you have enabled SNMP alerts on the
Add/Configure SNMP Alerts page.
Destination IP Address If the Available link appears under Destination IP Address, click the link to
open the Add/Configure SNMP Alerts page, which enables you to configure a
new alert.
Displays the destination IP address to which the corresponding alert is sent.
Click the IP address to open the Add/Configure SNMP Alerts window.
Community Displays the SNMP community to which the Destination IP Address belongs.
Table 4-10. SNMP Alerts Page Buttons
Button Action
Print Prints the SNMP Alerts page
Refresh Reloads the SNMP Alerts page