Dell Remote Access Controller 4 Firmware Version 1.30 Universal Remote User Manual


 
164 racadm Subcommand Man Pages
www.dell.com | support.dell.com
netstat
NOTE: To use this command, you must have Execute Diagnostic Commands permission.
Ta b le A-19 describes the netstat subcommand.
Synopsis
racadm netstat [<
network interface number
>]
ping
NOTE: To use this command, you must have Execute Diagnostic Commands or
Configure
DRAC 4 permission.
Ta b le A-20 describes the ping subcommand.
Synopsis
racadm ping <
ipaddress
>
setniccfg/getniccfg
NOTE: To use the setniccfg command, you must have Configure DRAC 4 permission.
NOTE: To use the getniccfg command, you must have Log In To DRAC 4 permission.
Ta b le A-21 describes the setniccfg and getniccfg subcommands.
Table A-19. netstat
Subcommand Definition
netstat Prints the contents of the routing table. If the optional interface number is provided,
then netstat prints additional information regarding the traffic across the interface,
buffer usage, and other network interface information.
Table A-20. ping
Subcommand Definition
ping Verifies that the destination IP address is reachable from the DRAC 4 with the
current routing-table contents. A destination IP address is required. An ICMP echo
packet is sent to the destination IP address based on the current routing-table contents.