Dell Remote Access Controller 4 Firmware Version 1.30 Universal Remote User Manual


 
80 Managing and Recovering a Remote System
www.dell.com | support.dell.com
Table 4-31. DRAC 4 Log Messages
Message ID Description Suggested Action
RAC186W DHCP: no response from server,
need LAN address. The NIC
cannot be enabled until a
response is received from the
DHCP server.
Provides information only. No specific
corrective action is indicated. Ensure that the
DHCP server is operational.
RAC188W DHCP: no response from server,
warm starting with <IP address>.
Provides information only. No specific
corrective action is indicated. Ensure that the
DHCP server is operational.
RAC189A Email page successful. Provides information only. No corrective
action is necessary.
RAC191E SNMP: internal failure during trap
generation.
Reset the DRAC 4 and retry the operation.
RAC198A SNMP: trap sent to <IP address>. Provides information only. No corrective
action is necessary.
RAC199W Email paging attempts failed,
SMTP protocol failure.
A trace of the SMTP connection may be
found in the trace log. Examine the trace log
to identify the source of the protocol failure,
such as the connection could not be
established (SMTP server is down or an
invalid IP address), an invalid email
destination address, an invalid domain in the
email address, or the SMTP server does not
support forwarding email. Correct the
problem and try again.
RAC256A
RAC257W
RAC258E
DRAC 4 hardware log event:
<formatted hardware log event>.
Provides information only. No corrective
action is necessary, unless the contents of the
hardware log indicate a problem. In this case,
the corrective action is based on the
problem
reported.
RAC016A DRAC 4 log cleared. Provides information only.
RAC030A DRAC 4 time was set. Provides information only.
RAC048A DRAC 4 firmware update was
initiated.
Provides information only.
RAC049A DRAC 4 Firmware Update was
initiated with config to defaults
option.
Provides information only.
RAC064A Clear crash screen. Provides information only.