Filter
Top Products
113
Chapter 3: Using the Logic Analyzer in Timing or State Mode
Cross-Triggering
2. Choose the Arm in from IMB menu item.
When the logic analyzer drives the arm signal
1. Set up the logic analyzer trigger as you would normally.
In the Trigger tab's Trigger Sequence area, the trigger actions will show
arm out to indicate that the logic analyzer's trigger will drive the arm
signal when it's trigger condition is satisfied.
2. Run the measurement.
See Also Intermodule Window (see the Agilent Technologies 16700A/B-Series
Logic Analysis System help volume)
Group Run Arming Tree (see the Agilent Technologies 16700A/B-Series
Logic Analysis System help volume)