Filter
Top Products
15
Chapter 1: Getting Started
Probing and Sampling Mode Selection Steps
Probing and Sampling Mode Selection Steps
You will always take the following steps regardless of the sampling
mode you plan to use.
• “Step 1. Connect logic analyzer to the device under test” on page 15
• “Step 2. Choose the sampling mode” on page 16
• “Step 3. Format labels for the probed signals” on page 19
Step 1. Connect logic analyzer to the device
under test
Before you begin setting up the logic analyzer for a measurement, you
need to physically connect the logic analyzer to your device under test.
There are four probing options available to connect your logic analyzer
to the device under test:
• Single-ended probes with Samtec connectors (see page 35).
• Differential probes with Samtec connectors (see page 37).
• Single-ended probes with MICTOR connectors (see page 39).
•Use an analysis probe to connect to microprocessors and standard buses.
When using an analysis probe, the Setup Assistant guides you through the
connection and setup process for your particular logic analyzer and
analysis probe.
Next: “Step 2. Choose the sampling mode” on page 16