Filter
Top Products
174
Chapter 5: Reference
The Format Tab
The Format Tab
The Format tab is used to assign bus and signal names (from the device
under test), to logic analyzer channels. These names are called labels.
Labels are also used when setting up triggers and displaying captured
data.
The Format tab also lets you assign pods to the logic analyzer and
specify the logic analyzer pod and clock threshold voltages.
The Data On Clocks display column shows the clock inputs available as
data channels in the present configuration, including the clocks on
expander cards which cannot be used in the clock setup.
The Format tab has activity indicators that show whether the signal on
a channel is above the threshold voltage (high), below the threshold
voltage (low), or transitioning.
NOTE: Activity indicated on channels may appear inaccurate or missing while a
measurement is still actively running in the state mode's 800, 1250, and 1500
Mb/s configurations.
• “Pod Assignment Dialog” on page 175
See Also “Formatting Labels for Logic Analyzer Probes” on page 57
“To assign pods to the analyzer” on page 57
“To set pod threshold voltages” on page 58
“To set clock threshold voltages” on page 59