Filter
Top Products
21
Chapter 1: Getting Started
Probing and Sampling Mode Selection Steps
Defined threshold voltage.
7. Select the Close button.
8. Select the Close button.
To assign names to logic analyzer channels
1. Select a label button, and either:
• Choose the Rename command, enter the label name, and select the OK
button.
• Or, choose the Insert before or Insert after command, enter the label
name, and select the OK button.
2. In the label row, select the button of the pod that contains the channels
you want to assign.
3. Either choose one of the standard channel assignments--dots (.) mean the
channel is unassigned, asterisks (*) mean the channel is assigned--or
choose Individual.
If you chose Individual:
a. In the "label - pod" dialog, select the channels you want to assign/
unassign.
b. Select the OK button.
Next:
• If you are using the logic analyzer in timing mode or in state mode, go to
“Step 4. Define the trigger condition” on page 22.
• If you are using the logic analyzer in eye scan mode, go to “Step 4. Select
channels for the eye scan measurement” on page 26.