Filter
Top Products
90
Chapter 3: Using the Logic Analyzer in Timing or State Mode
Setting Up Triggers and Running Measurements
To give an event list a name
1. In the Trigger tab's Trigger Sequence area, select the If, If not, Else if, or
Else if not button, and choose Name event list.
2. In the Name Event List dialog, enter the name and select the OK button.
To insert a named event
1. In the Trigger tab's Trigger Sequence area, select a label name button and
choose to insert or replace a Named event.
2. In the Named Event selection dialog, select the named event, and select
the OK button.
To edit a named event
1. In the Trigger tab's Trigger Sequence area, select the named event button
and choose Edit locally or Edit globally.
Locally means to edit (and rename) this instance of the named event.
Globally means to edit all instances of the named event.
2. In the Edit dialog, edit the event list as you would edit it in the Trigger
tab's Trigger Sequence area.
Saving/Recalling Trigger Setups
You can save a trigger setup within a session by using trigger save/
recall.
• “To save a trigger setup” on page 90
• “To recall a trigger setup” on page 91
• “To clear the trigger save/recall list” on page 91
See Also “Save/Recall Subtab” on page 191
To save a trigger setup
1. Set up the trigger.
2. In the Trigger tab's Save/Recall subtab, select the Save button.