Filter
Top Products
66
Chapter 2: Probing and Selecting the Sampling Mode
Formatting Labels for Logic Analyzer Probes
NOTE: Labels with reordered bits cannot be used as range terms or <, <=,>, >= in
triggers.
To turn labels off or on
When you temporarily want to remove a label and its data, you can turn
off the label. The label name and its bit assignments are preserved.
NOTE: In the timing mode's 400 MHz / 32M Sample Transitional or Store
Qualified configuration, the logic analyzer only looks for transitions on labels
that are turned on. Data is stored for the labels that are turned off, but only
when there is a transition on labels that are turned on. If you turn a label on
after a run, or re-assign a channel from a label that is turned off to a label that
is turned on, be aware that transitions on that label or channel are only
coincidental to labels that were turned on at the time of the run.
To turn a label off
1. In the Format tab, select the label button that you want to turn off.
2. Choose Label [ON] to toggle it off.
At least one label must remain on.
To turn a label on
1. In the Format tab, select the label button that you want to turn on.
2. Choose Label [OFF] to toggle it on.
To display a label that was off
1. Turn on the label.
2. At the bottom of the window, select the Apply button.
The label's data appears in the display windows.