Filter
Top Products
Setup Pages
49
MVP-8400i 8.4" Modero® ViewPoint® Touch Panel with Intercom
Environmental acoustics, personal voice level and ambient noise are all deciding factors when setting your mic, intercom
and panel sound levels. Consider your environment when adjusting intercom and sound levels and use caution so as not
to damage the speaker.
WAV files - Supported sample rates
The following sample rates for WAV files are supported by MVP-8400 panels:
Audio Settings Page (Cont.)
Master Volume: This section allows you to alter the current master volume level:
• Use the UP/DN buttons to adjust the volume level (range = 0 - 100).
• The Master Volume bargraph indicates the current volume level.
• The Mute button toggles the Mute feature.
• Default = 50.
Digital Audio Level: Adjusts the volume level on the panel’s internal speaker:
• Use the UP/DN buttons to adjust the volume (range = 0 - 100).
• The Internal Sound Level bargraph indicates the current sound level.
• The Mute button mutes the internal speaker volume.
• Default = 50.
Panel Sounds: • Activating the Button Hit button plays a default sound when you touch an
active button.
• Activating the Button Miss button plays a default sound when you touch a
non-active button or any area outside of the active button.
• The Play Test Sound button plays a test WAV/MP3 file over the panel’s
internal speakers.
• The singleBeep01 and doubleBeep02 buttons play a WAV/MP3 file over
the panel’s internal speakers of the user’s choosing. The panel has
several sample files already installed, and custom tones may be added.
• Activating the Panel Docking Tone Enabled button allows the use of a
tone to alert the user that the panel is properly docked in a desk or wall
docking station.
NOTE: If the custom tone files are not already installed on the panel as of the
last panel powerup, then the panel must be rebooted for it to recognize the new
files.
Intercom Mic Level: Adjusts the volume level on the panel’s microphone.
• Use the UP/DN buttons to adjust the microphone level (range = 0 - 100).
• The Mic Out Level bargraph indicates the current Mic Out level.
• The Mute button mutes the Mic volume.
• Default = 50.
Intercom Volume: Sets the volume level for intercom calls.
• Use the UP/DN buttons to adjust the Line-In volume level (range = 0 -
100).
• The Line-In Level bargraph indicates the current Line-In level.
• The Mute button mutes the Line-In volume.
• Default = 50.
Supported WAV Sample Rates
• 48000 Hz • 16000 Hz
• 44100 Hz • 12000 Hz
• 32000 Hz • 11025 Hz
• 24000 Hz • 8000 Hz
• 22050 Hz