Filter
Top Products
Setup Pages
55
MVP-8400i 8.4" Modero® ViewPoint® Touch Panel with Intercom
System Settings Page
The System Settings page (FIG. 53) displays sets the NetLinx Master’s communication settings.
The elements of this page include:
FIG. 53 System Settings page
System Settings Page Elements
Back: Saves all changes and returns to the previous page.
WiFi/Wired icon: The icon to the left of the Connection Status Icon displays whether the current
connection to the Master is Wireless (image of a radio antenna) or Wired
(image of three networked computers).
Connection Status icon: The icon in the upper-right corner of each Setup page shows online/offline state
of the panel to the master.
• Bright red - disconnected
• Bright green - connected. Blinks when a blink message is received to dark
green every 5 seconds for half a second then go back to bright green.
• Bright yellow - panel missed a blink message from the master. It will
remain yellow for 3 missed blink messages and then turn red. It will return
to green when a blink message is received.
Note: a Lock appears on the icon if the panel is connected to a secured NetLinx
Master.
Master Connection: Sets the NetLinx Master communication values:
Type Sets the NetLinx Master to communicate with the panel via either USB or
Ethernet. This is based on the cable connection from the rear.
Note: ICSNet is not a supported option on this panel.
• Ethernet is a CAT-5 cable (10/100Base T terminated in an RJ-45
connector) used to network computers together and is used in most LAN
(local area networks). This description is also used to refer to both wired
and wireless communication.
• USB option cannot be used on Modero panels that are not equipped with
a rear USB port.