AMX MVP-8400i Universal Remote User Manual


 
Setup Pages
57
MVP-8400i 8.4" Modero® ViewPoint® Touch Panel with Intercom
Wireless Settings Page
Use the options on the Wireless Settings page (FIG. 54) to configure communication settings for the wireless CF card
(802.11g), and read the device number assigned to the panel.
Features on this page include:
FIG. 54 Wireless Settings page (reads from and assigns values to the WAP)
Wireless Settings Page
Back: Saves all changes and returns to the previous page.
WiFi/Wired icon: The icon to the left of the Connection Status Icon displays whether the current
connection to the Master is Wireless (image of a radio antenna) or Wired
(image of three networked computers).
Connection Status icon: The icon in the upper-right corner of each Setup page shows online/offline state
of the panel to the master.
Bright red - disconnected
Bright green - connected. Blinks when a blink message is received to dark
green every 5 seconds for half a second then go back to bright green.
Bright yellow - panel missed a blink message from the master. It will
remain yellow for 3 missed blink messages and then turn red. It will return
to green when a blink message is received.
Note: a Lock appears on the icon if the panel is connected to a secured NetLinx
Master.
IP Settings: Sets the IP communication values for the panel:
DHCP/STATIC Sets the panel to either DHCP or Static communication modes.
DHCP - a temporary IP Addresses is assigned to the panel by a DHCP
server.
Static IP is a permanent IP Address assigned to the panel. If Static IP is
selected, the other IP Settings fields are enabled (below).
IP Address
Enter the secondary IP address for this panel.
Subnet Mask Enter the subnetwork address for this panel.
Gateway Enter the gateway address for this panel.
Host Name Enter the host name for this panel.
Primary DNS Enter the address of the primary DNS server used by this panel for host name
lookups.
Secondary DNS Enter the secondary DNS address for this panel.
Domain Enter a unique name to the panel for DNS look-up.