Filter
Top Products
14-10
User Guide for Cisco Digital Media Manager 5.2.x
OL-15762-03
Chapter 14 Touchscreens, Projectors, and Displays
Procedures
Related Topics
• Video and Audio Signal Interfaces, page 14-23
Connect to an Analog Display or Projector
Tip DMPs support connections to analog presentation systems. However, we recommend strongly that you use digital
presentation systems whenever possible.
Procedure
Step 1 Make connections for video.
a. Plug one yellow jack from the RCA video cable into the CVBS interface on the back panel of
your DMP.
b. Connect the free end of this cable to the corresponding interface on your presentation system.
Step 2 Make connections for audio.
a. Plug the 3mm jack on the RCA audio cable into the AUDIO interface on the back panel of
your DMP.
b. Connect the free end of this cable to the corresponding interface on your presentation system.
Step 3 If the presentation system is not already turned on, turn it On now.
Step 4 Stop. You have completed this procedure.
Related Topics
• Video and Audio Signal Interfaces, page 14-23