15-3
User Guide for Cisco Digital Media Manager 5.2.x
OL-15762-03
Chapter 15 DMP Remote Control and Its Emulation
Procedures
Procedures
In Cisco Unified Communications Manager
• Activate Services, page 15-3
• Start Services, page 15-4
• Configure URL Parameters, page 15-4
• Enable IP Phone Autoregistration, page 15-5
• Define IP Phone Service Attributes, page 15-5
• Expose the Service to IP Phones, page 15-6
In Cisco Cast
• Configure Emulator Settings in Cast, page 15-7
On Phones
• Configure an IP Phone to Emulate the Remote Control, page 15-8
• Start the Emulator on an IP Phone, page 15-9
• Start the Emulator on a Mobile Phone, page 15-10
• Use the Emulator on an IP Phone or a Mobile Phone, page 15-10
Activate Services
Procedure
Step 1 Log in to Cisco Unified Communications Manager Administration.
Step 2 Choose Cisco Unified Serviceability from the Navigation list, and then click Go.
Step 3 Choose Tools > Service Activation.
Step 4 Examine the Server list.
Step 5 Choose from it a server that should support remote control emulation.
Step 6 Click Go.
Step 7 Check the Check All Services check box.
Step 8 Click Save, and then click OK.
Step 9 Stop. You have completed this procedure.
What to Do Next
• Proceed to the “Start Services” section on page 15-4.