Filter
Top Products
14-12
User Guide for Cisco Digital Media Manager 5.2.x
OL-15762-03
Chapter 14 Touchscreens, Projectors, and Displays
Procedures
Activate RS-232 Syntax Support for a 42- or 47-inch Cisco LCD
Note This procedure applies exclusively to our 42-inch and 47-inch LCD display models. You can disregard this procedure if the
advertised diagonal measurement of your Cisco LCD display is 32, 40, 52, or 55 inches.
Our factory-default settings for this equipment save power by turning Off most of its support for remote
management and polling. Almost any attempt to use these features will fail while our energy-saving
settings remain in effect.
Would you like to manage or poll this equipment remotely from Cisco DMS? Before you can do so
reliably, you must complete a simple procedure that turns On the support for these features.
Later, at your discretion, you can again turn Off this support. Otherwise, when you leave it turned On,
this is a one-time procedure.
Before You Begin
• Connect this equipment to the DMP that will drive it.
• Plug in this equipment and turn it On.
Procedure
Step 1 Choose Digital Signs > Digital Media Players > Advanced Tasks.
Step 2 Click Add New Application.
a. Name the new application.
Are you turning On or turning Off the support for centralized management?
b. Choose Set from the Request Type list.
c. Enter the necessary command in hexadecimal.
Are you turning On or turning Off the support for centralized management?
d. Click Submit.
Step 3 Choose Schedules > Play Now, and then choose Advanced Tasks from the Select an Event Type list.
Step 4 Choose which application to run.
On Off
•
Use the Name field to enter a unique name
for your new application, such as
LCD_MANAGE_POLL_TURN_ON.
• Use the Name field to enter a unique name
for your new application, such as
LCD_MANAGE_POLL_TURN_OFF.
On Off
•
Use the Request field to enter exactly this
hexadecimal string:
rs232.tx_hex=64612030302030310D
• Use the Request field to enter exactly this
hexadecimal string:
rs232.tx_hex=64612030312030300D