Filter
Top Products
15-2
User Guide for Cisco Digital Media Manager 5.2.x
OL-15762-03
Chapter 15 DMP Remote Control and Its Emulation
Concepts
Workflow to Provision Emulator Service for IP Phones
You can provision a service from Cisco Unified Communications Manager that emulates the handheld
DMP remote control unit on Cisco IP phones. This workflow assumes that you are experienced as an
administrator in Cisco Unified Communications Manager and that you use it already to manage a
network of IP phones.
Tip Skip this workflow if you will not use any IP phones to emulate the remote control.
1. Complete these tasks in CUCM.
a.
Activate Services, page 15-3
b. Start Services, page 15-4
c. Configure URL Parameters, page 15-4
d. Enable IP Phone Autoregistration, page 15-5
e. Define IP Phone Service Attributes, page 15-5
f. Expose the Service to IP Phones, page 15-6
Note Emulator-related configuration changes that you make on your Cisco Unified Communications
Manager server do not become useful until after you also configure Cisco Cast to serve the
emulator, and configure at least one IP phone to run the emulator.
2. Complete these tasks in Cisco Cast.
•
Configure Emulator Settings in Cast, page 15-7
3. Complete these tasks on phones, as needed.
a.
Configure an IP Phone to Emulate the Remote Control, page 15-8
b. Start the Emulator on an IP Phone, page 15-9
c. Start the Emulator on a Mobile Phone, page 15-10
d. Use the Emulator on an IP Phone or a Mobile Phone, page 15-10
Note This workflow is based on Cisco Unified Communications Manager release 6.1. When you use any other release, the
workflow might differ slightly in your network. We recommend that you read on Cisco.com the particular revisions of these guides
that apply to your network.
• Cisco Unified Communications Manager Administration Guide
• Cisco Unified Serviceability Administration Guide