Filter
Top Products
15-9
User Guide for Cisco Digital Media Manager 5.2.x
OL-15762-03
Chapter 15 DMP Remote Control and Its Emulation
Procedures
Step 3 Go to Network Configuration, and then press Select.
Step 4 Go to Alternate TFTP, and then press Yes.
Tip If Alternate TFTP is not an option in the Network Configuration menu, contact the administrator for Cisco
Unified Communications Manager.
Step 5
Click Save.
The IP phone is restarted automatically, so that its configuration changes can take effect.
Step 6 Stop. You have completed this procedure.
Related Topics
• Workflow to Provision Emulator Service for IP Phones, page 15-2
• Use the Emulator on an IP Phone or a Mobile Phone, page 15-10
Start the Emulator on an IP Phone
Before You Begin
• Provision the emulator for use on Cisco IP phones.
• Configure emulator settings in Cisco Cast.
• Configure your IP phone to emulate the remote control.
• Make note of the generated PIN code in the top-right corner of a DMP display that is showing
Cisco Cast. The emulator cannot control the corresponding DMP without this PIN.
Procedure
Step 1 Press Services on your Cisco IP phone.
Step 2 Highlight the remote control option in the services list, and then press Select.
Step 3 Tap the PIN field on your touchscreen.
Step 4 Use the keypad to enter the PIN code.
Step 5 Tap Submit on the touchscreen.
The touchscreen is refreshed and the emulator starts.
Step 6 Stop. You have completed this procedure.
Related Topics
• Workflow to Provision Emulator Service for IP Phones, page 15-2
• Configure Emulator Settings in Cast, page 15-7
• Use the Emulator on an IP Phone or a Mobile Phone, page 15-10