Filter
Top Products
103
Monitoring and Controlling Projectors via a Network (for the EMP-7900)
User’s Guide
Problem Reporting Using the Mail Notification
Function
If EMP NetworkManager has been used to make the settings for the mail
notification function, notification messages can be sent to a computer with
a preset e-mail address when a problem or warning occurs with a projector
connected to the network. This will notify the e-mail recipient that there is
a problem with the projector.
Check the following points before starting up EMP NetworkManager.
• EMP NetworkManager must be installed in the computer to be used for
monitoring and control. p.99
• The computer and the projector must be connected to the network.
p.101
PROCEDURE
With Windows running, click [Start], point to
[Programs] (or [All Programs]), point to [EPSON
Projector] and then click [EMP NetworkManager].
EMP NetworkManager will start up.
Double-click the icon for the projector to set mail
notification for.
If the name for the required projector is not displayed, refer to
"Connecting Manually". p.106
If a password has been set, the password entry dialog box will
be displayed.
TIP
• Up to a maximum of three notification destinations (addresses) can
be recorded, and notification messages can be sent to all three
destinations at once.
• If a critical problem develops with a projector which causes it to
suddenly stop working, it may not be possible for the projector to
send a message notifying an operator of the problem.
• If "Standby Mode" in the projector's "Advanced1" menu is set to
"Network ON", monitoring can be carried out even when the
projector is in standby mode (when the power is off). p.91
Mail Notification Settings
1
2
Projector
address...
EMP482800...
192.168.0.8
PROJECTOR01
169.254.10.176
PROJECTOR02
169.254.10.177
PROJECTOR03
169.254.10.178
Room201
169.254.207.64
Room202
169.254.207.65
Room301
169.254.207.66
Room302
169.254.207.67
Room303
169.254.207.68
Room401
169.254.207.69