Filter
Top Products
59
Preventing theft (Password Protect)
User’s Guide
The password entry screen will not be displayed at all when the power is
turned on until the length of time that has been set has elapsed. When the
set length of time has elapsed, the password entry screen will be displayed
each time the power is turned on. The length of time referred to here is the
total illumination time for the projector's lamp from the point when the
projector's menu is closed.
If "Password Timer" is set to "OFF", the password entry screen will be
displayed each time the power plug is disconnected and reinserted from the
electrical outlet. If the projector's power on when it is in standby mode, the
password entry screen will not be displayed.
If an attempt is made to carry out any of the following user logo
operations, a message is displayed and the setting cannot be changed. To
change the setting, set "User’s Logo Protect" to "OFF" first. p.61
• Capturing a user's logo
• Changing the setting for the "No-Signal Msg." command in the "Setting"
menu from "Logo" to "Black", "Blue" or "OFF", or when changing it
from "Black", "Blue" or "OFF" to "Logo"
• Changing the setting for the "A/V Mute" command in the "Setting" menu
from "Logo" to "Black" or "Blue", or when changing it from "Black" or
"Blue" to "Logo"
• When the "Advanced1" - "Startup Screen" menu setting ("ON" or "OFF")
is changed.
TIP
• If an incorrect password is entered three times in succession, the
message "The projector’s operation will be locked." will be displayed
for approximately five minutes, and then the projector will switch to
standby mode. If this happens, disconnect the power plug from the
electrical outlet and then reinsert it and turn the projector's power
back on. A window requesting you to enter the password will be
displayed, so enter the correct password.
If you happen to forget the password, make a note of the "Request
Code: xxxxx" number that appears in the Password screen and
contact the nearest address provided in the "International Warranty
Conditions" section of the Safety Instructions/World-Wide Warranty
Terms booklet.
• If you repeat the above operations ten times resulting in an incorrect
password being entered thirty times, the following message will be
displayed and the projector will not accept password entries any
more.
"The projector’s operation will be locked. Contact the nearest
address provided in the "International Warranty Conditions" section
of the Safety Instructions/World Wide Warranty Terms booklet."
When "Password Timer" is set to "ON" and "Timer" is used
When "User’s Logo Protect" is enabled (ON)