Filter
Top Products
148
User’s Guide
Saving a User's Logo
You can record the image that is currently being projected as a user's logo.
PROCEDURE
Project the image that you would like to use as a
user's logo, and then press the [Menu] button on
either the remote control or the projector's control
panel.
Select the "User's Logo" menu, and then press the
[Enter] button on the remote control or the [Auto/
Enter] button on the projector's control panel.
Select "Yes" in the sub-menu, and then press the
[Enter] button on the remote control or the [Auto/
Enter] button on the projector's control panel.
TIP
• When a user's logo is recorded, the previous user's logo will be
erased.
• You cannot save a new user's logo if "User's Logo Protect" in the
Password Protect settings has been set to "ON". Set "User's Logo
Protect" to "OFF" and then save the new user's logo. p.61
1
2
[ ]: Select
Execute
Video
Audio
Effect
User's Logo
Advanced1
About
Reset All
[ ]: Execute [Menu]: Exit
[ ]: Select
Setting
Advanced2
TIP
If keystone correction or the E-Zoom function have been used, they
will be cancelled when the "User's Logo" menu is selected.
3
Accept the present image as user's logo?
User's Logo
YES
NO
TIP
When you press the [Enter] button on the remote control or the [Auto/
Enter] button on the projector's control panel, the images will be
projected at their original image signal resolution, so that when you
are projecting images which have a resolution that is different from
the number of pixels on the projector's panel, and when you are
projecting video images, the display size will change.