Filter
Top Products
110
Centralised Control using EMP Monitor
User’s Guide
Once all new projectors to be monitored have been
added, click [Close].
The display will return to the Register projector window, and
the names of the added projectors will appear in the projector
list.
Once all target projectors have been registered, click
[Close].
If there are any projectors in the list that you do not need to
monitor, select the Projector name and then click [Delete].
The statuses of the registered projectors will each be
displayed.
Once a projector has been registered, the status of the projector
will be displayed automatically each time EMP Monitor is
started from then on.
The following table shows the display details.
6
: Projectors registered using the Manual registration function
: Projectors registered using the Auto detect function
7
TIP
If the IP addresses
g
for projectors that have been registered using the
Manual registration function have changed, you can select the
Projector name and then click [Edit] to change the IP address. [Edit]
cannot be used for projectors that have been registered using the Auto
detect function.
Status :
The projector statuses are indicated by means of the following
icons.
Power ON with no problems
Power OFF with no problems
Power ON with a problem
Power OFF with a problem
Network error (not connected to network, power cable is
not connected, etc.)
Name :
Shows the name of the projector.
8