Filter
Top Products
93
Using the Configuration Menu FunctionsUsing the Configuration Menu Functions
User’s Guide
Direct
Power ON
When the projector's power cable is connected, projection
starts without needing to press the [Power] button.
*When "Direct Power ON" is set to "ON", turn the power
off by pressing the [Power] button, then wait for the cool-
downg period to finish and then disconnect the power
cable. If the power cable is left connected to the wall
outlet when "Direct Power ON" is set to "ON", the
projector will turn on if a power outage occurs and then
the power is restored.
OFF
Operation
Lock
When set to "ON", the operation of all buttons on the
projector's control panel except for the [Power] button will
be disabled.
•When "Operation Lock" is set to "ON", the operation lock
function can be cancelled by holding down the [Enter]
button on the projector's control panel for approximately 7
seconds.
•If you change the setting, the new setting will take effect
after exiting the configuration menu.
OFF
Reset Resets all adjustments values for the "Advanced2" menu
functions except for the "Projector ID" and "Network"
settings to their default settings.
•Press the [Enter] button on the remote control or the
[Auto/Enter] button on the projector's control panel to
reset.
•Select "Reset All" to reset all menu settings – including
settings for the "Video" and "Audio" menus – to their
default settings. p.95
-
Sub-menu Function Default