Filter
Top Products
108
User’s Guide
Centralised Control using EMP Monitor
EMP Monitor can be used to check the statuses of multiple projectors that
are connected to the network and to carry out operations such as turning
the power for the projectors on and off and changing the signal sources, all
using a single computer. If there are several projectors that have been set
up in different classrooms or meeting rooms, for instance, they can all be
started at once and monitored by a single operator.
Check the following points before starting up EMP Monitor.
• EMP Monitor must be installed in the computer to be used for monitoring
and control. p.99
• The computer and the projectors must be connected to the network.
• If using Windows 2000/NT4.0/XP, installation can only be carried out by
a user who is logged in as administrator.
PROCEDURE
With Windows running, click [Start], point to
[Programs] (or [All Programs]), point to [EPSON
Projector] and then click [EMP Monitor].
EMP Monitor will start up.
If EMP Monitor is being started up for the first time
after it was installed, or if you would like to register
additional projectors, click the [Register projector]
icon. If all projectors are already registered and you
do not want to add any new projectors, skip to step 8.
TIP
• A maximum of 64 projectors can be monitored and operated all at
once in this way.
• If "Standby Mode" in the projector's "Advanced1" menu is set to
"Network ON", EMP Monitor can be used to carry out network
monitoring and control functions even when the projector is in
standby mode (when the projector's power is turned off).
1
2