Filter
Top Products
156
User’s Guide
List of ESC/VP21 Commands
Command List
When a power on command is sent to the projector, the power will turn on
and the projector will change to warm-up mode. When the power has
turned on, a colon ":" (3Ah) will be returned.
When the projector executes a command, it returns a ":" and waits for the
next command to be sent.
If command processing terminates with an error, the projector outputs an
error message and then returns the ":" code.
* When issuing any of the above commands, tack a Carriage Return (CR)
code (0Dh) on to the end.
Communication Protocol
Item Command
Power ON/OFF
ON PWR ON
OFF PWR OFF
Signal selection
Computer SOURCE 10
DVI
g
SOURCE 30
Video SOURCE 41
S-Video SOURCE 42
BNC SOURCE B0
A/V Mute ON/OFF
ON MUTE ON
OFF MUTE OFF
A/V Mute Selection
Black MSEL 00
Blue MSEL 01
User's Logo MSEL 02
•
••
•
Standard baud rate : 9600 bps
•
••
•
Data length : 8 bits
•
••
•
Parity : None
•
••
•
Stop bit : 1 bit
•
••
•
Flow control : None
•
••
•
Connector shape : D-Sub 9-pin (male)
•
••
•
Projector input port : Control (RS-232C)