Filter
Top Products
40
User’s Guide
Turning the Projector Off
Follow the procedure below to turn the projector off.
PROCEDURE
Turn the power off for the signal sources that are
connected to the projector.
Check that the power for all connected components has been
turned off.
Press the [Power] button on either the remote control
or the projector's control panel.
The following confirmation message will appear.
If you do not want to turn the power off, press a button other
than any of the following:
• At the remote control: [Power], [ ], [ ], [ ], [Num], [ID]
• At the control panel : [Power]
If you do not press any button, the message will disappear
automatically after seven seconds. (The power will not turn off
at this time.)
Press the [Power] button on either the remote control
or the projector's control panel once more.
The lamp will switch off. The indicator will flash orange and
cool-down
g will start.
The cool-down period lasts for about 20 seconds.
When cool-down is complete, the indicator lights orange.
1
2
Remote control
Power OFF?
Yes
: Press button
No : Press any other button
TIP
If the message "The projector is overheating. Make sure nothing is
blocking the air vent, and clean or replace the air filter." appears on
the screen, press the [Enter] button on the remote control or the
[Auto/Enter] button on the projector's control panel to turn the power
off and then clean the air filters. p.140
3
Stops flashing and lights orange
TIP
• The remote control and projector's control panel buttons cannot be
operated while the indicator is flashing orange. Wait until it lights
constantly.
• If "Standby Mode" in the configuration menu is set to "Network
ON", fans will continue operating. This is normal and does not
indicate a problem.