Filter
Top Products
104
Monitoring and Controlling Projectors via a Network (for the EMP-7900)
User’s Guide
Connection of the projector will start, and the following
Setup for Network Projector window will be displayed.
If "DHCP" is set to "OFF", the settings for the "Network"
function in the "Advanced2" menu will be displayed. Make any
changes that are necessary.
The projector name can consist of up to 15 single-byte
alphanumeric characters. Hyphens(-) also can be used. Note
that a numeric-only name can not be set.
Once the network settings for the projector have been
completed, click [Mail Notification Setting] and make
the settings for mail notification such as the
notification destinations.
The following Setup of mailing functions window will
be displayed.
The following table shows the setting details for each item.
3
4
5
Mail
Notification
function
Set to "ON" to use the mail notification function.
IP address
g of
SMTP server
Specify an IP address of the SMTP server.
You can enter numbers from 0 to 255 in each field of the
IP address. However, the following IP address cannot be
used.
127.x.x.x, 224.0.0.0 to 255.255.255.255
(where x is a number between 0-255)
When you change a port number of the SMTP server,
specify this port number. The default value is "25".
You can enter a valid number from 1 to 65535.
Destination
address
1/2/3
Specify the destination address of the notification mail.
Up to three destinations can be set. You can enter up to
53 single-byte alphanumeric characters.
The address you have set as "Destination address 1" is
also used as the source address.
Setting a
Notification
Event
Use this to select the events that cause a mail notification
to be sent when a problem or warning occurs with the
projector.
You can select one or more of the following.
• Internal error • Fan related error. • Sensor error
• Lamp timer failure • Lamp out • Lamp cover is
open
• Internal temperature error
• High-speed cooling in progress
• Lamp replacement notification •No-signal