Filter
Top Products
97
Using the Configuration Menu Functions
User’s Guide
Select a setting value.
Tilt the [ ] button on the remote control or press the [ ] or [ ]
button on the projector's control panel to change setting values.
For items which are currently set, a appears in green next to
the setting. If you tilt the [ ] button on the remote control or
press the [ ] or [ ] button on the projector's control panel to
select an item to be set, the will appear in orange. After
making the selection, press the [Enter] button on the remote
control or the [Auto/Enter] button on the projector's control
panel to accept the setting. When the setting is accepted, the
changes to green.
Select other menu items in the same way.
Repeat steps 2 to 5 to change the settings for other menu items.
To return to a previous menu, press the [ESC] button on either
the remote control or the projector's control panel.
Close the menu.
Press the [Menu] button on either the remote control or the
projector's control panel.
TIP
The items appearing in the "Video" menu and the "About" menu will
vary depending on the type of input source being projected.
5
Standby Mode
:
Color Adjustment
Color Temp. RGB
Rear Proj.
Language Select [English]
Reset
Execute
Adjust
ON OFF
:
:
Ceiling ON OFF
:
Network ON Network OFF
Startup Screen ON OFF
:
Progressive
:
OFF Video Film/Auto
TIP
• Sub-menu items which cause another sub-menu to be displayed
when they are selected have after them. If you select such menu
items and press the [Enter] button on the remote control or the
[Auto/Enter] button on the projector's control panel, you can then
change the settings in the next sub-menu which appears.
• Refer to "List of Functions" for details on the functions of each
menu item. p.78
6
7
TIP
The display position for configuration menus can be set to either the
top-left or the bottom-right of the images. If you press the [Menu]
button on either the remote control or the projector's control panel
twice in succession when displaying a configuration menu, the
configuration menu will be displayed in a different position from
before. If you would like to change configuration menu settings while
checking images, select an appropriate point in the projection and
then display the configuration menu.