Filter
Top Products
92
Using the Configuration Menu FunctionsUsing the Configuration Menu Functions
User’s Guide
"Advanced2" Menu
Brightness Control High Low
:
Video
Audio
Setting
User's Logo
Advanced1
About
Reset All
Projector ID
Network
Reset
Execute
: 1
[Menu]: Exit[ ]: Enter[ ]: Select
Effect
Advanced2
COM Port
BNC Sync Termination
:
ON OFF
:
Direct Power ON
ON OFF
:
Operation Lock
ON OFF
:
Set
Set
RS-232C USB
Auto Setup
ON OFF
:
Sub-menu Function Default
Brightness
Control
This lets you set the lamp brightness to one of two settings.
Select "Low" if the images being projected are too bright
such as when projecting images in a dark room or onto a
small screen.
When "Low" is selected, the brightness of the images is
reduced, but the amount of electricity consumed and noise
produced during projection are reduced and the lamp's
operating life is extended.
High
Projector
ID
Sets the ID number for the projector. p.74 1
Network (EMP-7900 only)
Sets the DHCPg, IP Addressg, Subnet Maskg and
Gatewayg Address when the projector is connected to a
network and the EMP Monitor function or mail notification
function are being used. It also lets you set the IP address
for a computer to use for notification of problems when
using SNMPg for network monitoring. p.101
-
COM Port This can be set to either "RS-232C" or "USB" depending on
the port that is being used for communication with a
computer.
To enable the new settings, turn the projector's power off
and wait until the cool-downg is finished.
RS-232C
Auto Setup Selects whether the automatic adjustment function for
automatically optimising images when the input source is
switched to computer analogue images.
ON
BNC Sync
Termination
Sets the termination mode for the [BNC] port. This is used
for image terminal processing.
•ON : Analogue (75 Ω) termination
•OFF: TTL (Normal signal level output by the computer)
input
This should normally be set to "OFF". If an analogue (75
Ω) termination such as for a switcher is required, change
the setting to "ON".
OFF